Pas opelį su pirmos kartos TPMS reikia atlikti tokią procedūrą:

Service:

If a customer is trying out the TPMS (e.g. by inflating the right tyre to a higher pressure), the display may indicate the wrong side of the vehicle (i.e. it may show that the left tyre has a higher pressure).

Not until the vehicle is driving along will the previously programmed DDS then allocate the wheel or sensor correctly, after which the display in the Info Display will be correct.

Should the customer have concerns, assign the tyre pressure sensors unambiguously to the TPMS control unit by using the following programming procedure:

Version 1:
Reduce the tyre pressure to approx. 1 bar and re-inflate as described below.
Proceed with each tyre in turn.


Front left: 3.0 bar
Front right: 2.7 bar
Rear right: 2.4 bar
Rear left: 2.1 bar


Tyre pressure sensors are now active.


Lawrence Jamieson <lj@lietuva.lt> Wrote in message:r
> 2021-09-28 23:05, Dainiushas rašė:> o kaip atsirenka kur kuris ratas?Atsirenka kažkaip. Iš mano auto manualo:Changing Wheels With a Tire Pressure Monitoring SystemWhen changing the wheels of your vehicle, the tire pressure monitoring system needs to relearn the tire pressure sensors. To achieve this perform the following:1. Make sure all tires are inflated to the proper pressure. If not, inflate the tires to the correct pressure.2. Park your vehicle for at least 20 minutes.3. Carry out the tire pressure monitoring system reset procedure. See Tire Pressure Monitoring System Reset Procedure later in this section.4. The tire pressure monitoring system automatically re-learns the tire pressure sensors the next time your drive your vehicle for approximately 15 minutes above 25 mph (40 km/h).


-- 




----Android NewsGroup Reader----
https://piaohong.s3-us-west-2.amazonaws.com/usenet/index.html