Kai prasides problemos su strymeriu (ar juostom), ir jei an to paties
kontrolerio sisteminis diskas - bus daug vertingos patirties.

On 04/02/10 18:09, arulis wrote:
> nu va aciu labai, jau kazka dmesgas atrado po sio skriptuko:
>  for x in /proc/driver/cciss/cciss[0-9]*
>         do
>                 echo "engage scsi" > $x
>         done
> 
> 
> scsi2 : cciss
>   Vendor: HP        Model: DAT160            Rev: WS92
>   Type:   Sequential-Access                  ANSI SCSI revision: 03
> st 2:0:0:0: Attached scsi tape st0
> st0: try direct i/o: yes (alignment 512 B)
> st 2:0:0:0: Attached scsi generic sg1 type 1
> st0: Block limits 1 - 16777215 bytes.
> 
> Kokie dar niuansai gali buti, jei sakai kad bus nefaina
> 
> 
> 
> "rabarbaras" <rabarbaras@zebra.lt> wrote in message 
> news:hp3uq3$8jl$1@trimpas.omnitel.net...
>> su cciss bus nefaina. Paskaityk kernelio
>> Documentation/blockdev/cciss.txt
>>
>> On 04/01/10 22:41, arulis wrote:
>>> Sveiki, uzveskit ant kelio:
>>> prisireike pakurti subj. po centos5 x64 . nesusidures anksciau su 
>>> juostom,
>>> tai ir uzsiknisau.
>>>
>>> hardwaras  proliant su P410i smartarray.
>>>
>>> BIOSE arrajaus utilitke rodo SAS RAID-1 masyveli ir Tape irengini.
>>> po linuxu niekas nieko neranda - nei HP tape diagnostic toolsas.
>>>  nezinau net kur ieskoti sio irenginio tarp /dev/*
>>> /dev/cciss/p0d0 /dev/cciss/p0d0p* mato tik diskus . dmesg nieko neradau 
>>> kad
>>> detektuotu.
>>> modprobe st - niekas nepasikeite.
>>> dar bandziau su atskira HP p212 smart array ploste - biose mato, po 
>>> linuxu
>>> atsiranda tik toks irenginys
>>> /dev/cciss/p1d0
>>>
>>>
>>>
>>>
> 
>