nu va aciu labai, jau kazka dmesgas atrado po sio skriptuko:
 for x in /proc/driver/cciss/cciss[0-9]*
        do
                echo "engage scsi" > $x
        done


scsi2 : cciss
  Vendor: HP        Model: DAT160            Rev: WS92
  Type:   Sequential-Access                  ANSI SCSI revision: 03
st 2:0:0:0: Attached scsi tape st0
st0: try direct i/o: yes (alignment 512 B)
st 2:0:0:0: Attached scsi generic sg1 type 1
st0: Block limits 1 - 16777215 bytes.

Kokie dar niuansai gali buti, jei sakai kad bus nefaina



"rabarbaras" <rabarbaras@zebra.lt> wrote in message 
news:hp3uq3$8jl$1@trimpas.omnitel.net...
> su cciss bus nefaina. Paskaityk kernelio
> Documentation/blockdev/cciss.txt
>
> On 04/01/10 22:41, arulis wrote:
>> Sveiki, uzveskit ant kelio:
>> prisireike pakurti subj. po centos5 x64 . nesusidures anksciau su 
>> juostom,
>> tai ir uzsiknisau.
>>
>> hardwaras  proliant su P410i smartarray.
>>
>> BIOSE arrajaus utilitke rodo SAS RAID-1 masyveli ir Tape irengini.
>> po linuxu niekas nieko neranda - nei HP tape diagnostic toolsas.
>>  nezinau net kur ieskoti sio irenginio tarp /dev/*
>> /dev/cciss/p0d0 /dev/cciss/p0d0p* mato tik diskus . dmesg nieko neradau 
>> kad
>> detektuotu.
>> modprobe st - niekas nepasikeite.
>> dar bandziau su atskira HP p212 smart array ploste - biose mato, po 
>> linuxu
>> atsiranda tik toks irenginys
>> /dev/cciss/p1d0
>>
>>
>>
>>