Pasirodo su atmega64 neveikia (su atmega8 gerai). Pries softo updeita veike. 
Visgi kitaicu hexas buvo geresnis.

avrdude -p atmega64 -P com1     -c usbasp     -B 6 -U flash:w:main.hex

avrdude: set SCK frequency to 93750 Hz
avrdude: AVR device initialized and ready to accept instructions

Reading | ################################################## | 100% 0.02s

avrdude: Device signature = 0x1e9602
avrdude: NOTE: "flash" memory has been specified, an erase cycle will be 
performed
         To disable this feature, specify the -D option.
avrdude: erasing chip
avrdude: set SCK frequency to 93750 Hz
avrdude: reading input file "main.hex"
avrdude: input file main.hex auto detected as Intel Hex
avrdude: writing flash (2064 bytes):

Writing | ################################################## | 100% 1.34s

avrdude: 2064 bytes of flash written
avrdude: verifying flash memory against main.hex:
avrdude: load data flash data from input file main.hex:
avrdude: input file main.hex auto detected as Intel Hex
avrdude: input file main.hex contains 2064 bytes
avrdude: reading on-chip flash data:

Reading | ################################################## | 100% 1.30s

avrdude: verifying ...
avrdude: verification error, first mismatch at byte 0x0100
         0xff != 0x90
avrdude: verification error; content mismatch

avrdude done.  Thank you.

make.exe: *** [program] Error 1






"AMB" <jhlkjj@llkjhk.lt> wrote in message 
news:lguemc$bnr$1@trimpas.omnitel.net...
> didelis dekui tau, pasirodo viskas ok su -B  6.
>
>
> "dpi" <dpi@epastas.lt.lt.lt> wrote in message 
> news:lgsmrb$gnv$1@trimpas.omnitel.net...
>> Pamenu atnaujines usbasp firmwara pradejau naudoti -B opcija. Lyg su 
>> naujesne versija ir atsirado si galimybe (softwarine), nebereikia to 
>> jumperiuko naudoti.
>> Pabandyk pvz -B 6 (be jumperiuko).
>>
>>
>
>