galima tiksliau? :)
ir kodel?

Ginciakas Wrote:

> imk geriau pionieriu
> 
> "mumum�ik zergatronas" <zz@mumumba.zerg> wrote in message 
> news:ifg8k4$cbq$1@trimpas.omnitel.net...
> > ple. kuo toliau i miska tuo daugiau medziu...
> > del vieno optical in gal nera taip baisu.. kompa galima per coax paleist..
> > bet kad is skaitmeninio saltinio i 2 zona negalima paduot tai cia dekui uz 
> > pastebejima..
> > 28xx/31xx be abejo gerai butu, bet ten kainu kategorija tokia, kad turbut 
> > antras stipras ir pigiau ir lanksciau gautusi..
> > gerai bent tiek, kad garso kortos analoginis isejimas ne ka blogesnis nei 
> > skaitmena.. :)
> >
> > del biamp taip ir itariau, kad naudojami 2 zonos isejimai
> > praktiskai koks avr1910 kinui ir kokia rega brio butu optimalu..
> > gaunasi "kino" ir "muzikos" sistemos atskiros..
> > tik kinui tuomet pritruks soniniu koloneliu.. bet kazkaip man ju ir dabar 
> > netruksta, ko negaliu pasakyt apie centrine.. :)
> >
> > 2010.12.29 21:22, Icetom ra��:
> >> ?
> >> *) Dar atkreipk d�mes�:
> >>
> >> "Q. Okay, I hooked it up just like you said, turned on Zone 2, selected a 
> >> source... but no sound! Whay am I doing wrong?
> >> A. For all Denon receivers below the 280X/98X level, Zone 2 is ANALOG 
> >> ONLY!!. This means your cable box hooked up with optical audio, your PS3 
> >> hooked up with HDMI, etc. will NOT be output to Zone 2
> >>
> >> All is not lost, however. All you need to do is, for any source which you 
> >> would like to output to Zone 2, just "double up" your connection by 
> >> running a second set of analog RCA cables (red/white) from the analog 
> >> outs of your source to the corresponding input on the back of the Denon."
> >>
> >> T.y. tau reikt� orientuotis � ne �emiau kaip 280x modelius normaliai 
> >> garso kokybei ;)
> >>
> >> **) Taip, neklydau - bi-amping negal�si daryti nes:
> >>
> >> "Q. How do I hook up a pair of Zone 2 speakers?
> >> A. There are two ways to hook up Zone 2 speakers to your Denon AVR:
> >> 1. If you are only running 5.1 in your main zone, you can reassign your 
> >> SURROUND BACK amplifiers to power the Zone 2 speakers. To do this, go to 
> >> MANUAL SETUP > OPTION SETUP > AMP ASSIGN and set the assignment to "Zone 
> >> 2". With this setup, you will hook up your two surround speakers with 
> >> normal speaker wire and connect them to the SURR.BACK LEFT/RIGHT speaker 
> >> posts on the back of the receiver. The receiver will power the speakers, 
> >> and you will also be able to control the volume for Zone 2 in the 
> >> receiver. "
> >> 2-u atveju reikia atskiro stereo stiprintuvo ;)
> >>
> >> http://batpigworld.com/fadq.html#multizone 
> 
>