Jei ner kitu klaidu, TIS siulo arba patikrint laidus, arba kuro sistemos
sandaruma.
A B-01 DIAGNOSTIC TROUBLE CODE
T07 P1630 Fuel-Injection Quantity Circuit High Input
a.. Engine speed is greater than 1500 rpm
b.. Pedal position sensor signal is less than 5 %
c.. Short circuit to voltage at the fuel-injection quantity solenoid valve
Effect:
a.. Engine is stopped.
Concerned Terminals:
91, 99, 100, 105
Work Order Description Nominal Value
a.. Ignition OFF
b.. Disconnect wiring harness connector from:
K128 Control Unit - Injection Pump
c.. Ignition ON
d.. Measure voltage between the following terminals:
K128 Control Unit - Injection Pump
Wiring harness connector (wiring harness side) terminal 7
&
Ground
greater than 11 V
A B-01 DIAGNOSTIC TROUBLE CODE
T07 P1630 Critical system malfunction 1 (refer to checking
procedure: trouble code description)
a.. The current consumption of the injection fuel quantity solenoid valve
is out of range.
Effect:
a.. Maximum performance will be reduced.
Work Order Description Nominal Value
Important:
The fuel system is very sensitive. Work should be done with high
cleanliness and care. Air in the fuel system can cause damage of the
injection pump. That's why the fuel tank must never be driven empty.
a.. Check fuel tank for correct fuel sort content
b.. Check the concerned system for leaks
c.. Check the correct fitting of the connections and sealing.
(use only sealing, that is approved by the vehicle manufacturer)
d.. Plugging, leakage, air or water in fuel system
Note:
Bleed fuel system with KM-948 and suitable adapters.
"Domas" <domasback@gmail.com> wrote in message
news:jt1oeq$5n0$1@trimpas.omnitel.net...
> Po kompu pajungus rodo - P1630(A)
> Gal kas nors galetu pakomentuot kas tai ?
>
> D.
>
> On 2012-07-03 11:51, Staska wrote:
>> Jungt kontuperi ir ziuret ka pasakys.
>>
>>
>