nu blet tu uzhspaminai..

"Nero" <arturasr_NEREIKIA_@eircom.net> wrote in message 
news:hjapc3$kfo$1@trimpas.omnitel.net...
> na stai - kaip ir sakiau:
>
> June 1991
> Service Bulletin 24 01 91 (3196)
>
> Subject: Transmisison Failure during Exhaust Emission Testing
>
> Models: All 1984, 1985, 1986 with 4-speed automatic transmission, 1987
> 635CSi, 735i, and L7.
>
> Situation: There have been reported isolated cases of automatic
> transmissions failing during a High Idle Exhaust Emissions Check. The
> failures have resulted from a preconditioning procedure where the engine 
> is
> held at high rpm for a prolonged period of time. The following applies to
> all states which have a High Idle Exhaust Emission Check.
>
> As the internal transmission components experience normal wear over time,
> the possibility of transmission damage exists if the vehicle is operated
> for
> extended periods of time at high rpm in PARK or Neutral. Such operation
> does not constitute normal operating conditions. If, in exceptional cases
> such as A/C recharging, injector cleaning, charging system tests, or
> emissions testing, vehicle operation at high rpm in PARK or Neutral is
> required the following setup procedure must be performed prior to 
> beginning
> such operations.
>
> Solution: The emissions test must be conducted with the engine at
> operating
> temperature. If the engine is not at operating temperature prior to
> beginning the test, it is recommended that the vehicle be driven for a
> short
> period of time to bring the engine to operating temperature. DO NOT run
> the
> vehicle at high idle to achieve operating temperature.
>
> Once the engine has reached operating temperature, the following pretest
> procedure must be performed BEFORE testing begins.
>
> Setup Procedure for I/M Emission Test
>
> 1. Shift to PARK.
> 2. Turn engine OFF.
> 3. Wait at least 30 seconds.
> 4. Restart engine, LEAVE TRANSMISSION IN PARK.
> After the engine is started, DO NOT move the gear shift selector through
> the
> Forward or Reverse gears before or during the test sequence. DO NOT EXCEED
> 2000 RPM.
> 5. Begin emissions test procedure.
> 6. If the vehicle fails the emission test, some states allow for an
> extended pre-conditioning before the repeat test. In this case the
> following procedure should be adhered to.
>
> Precondition Procedure
>
> 1. Shift into PARK and turn the engine OFF for 30 seconds.
> 2. Restart engine, LEAVE TRANSMISSION IN PARK.
> 3. Engine may be preconditioned at a maximum of 2000 RPM for up to 90
> seconds, at which time the repeat test must begin.
>
> If the above steps are not followed, serious transmission damage can
> result.
>
> Note: Due to the unusual nature of the emissions check, this type of
> failure does not take place under normal operating conditions.
>
>
>
> "Nero" <arturasr_NEREIKIA_@eircom.net> wrote in message...
>> Parasyta negazuot ant parkingo ir neutralaus - as tai negazuociau, bet 
>> techninej apziuroj tai negras (netikintis kad tokia "ziauriai sena" 
>> masina gali but tvarkinga) - spaudzia is paskutinio prakaito gaza 10-15 
>> min stengdamasis ivaryt kuo daugiau to CO ir yrodyt sau kad jis galvoja 
>> teisingai.. Idomu jei tokio patikrinimo metu sugadinama deze - kas tada 
>> kaltas tokiu atveju? Jei user manuale buna parasyta kad negalima gazuot - 
>> kaip ir atsakomybe turetu nest techniniu apziuriu centras del 
>> nekvalifikuoto personalo???
>
>